Aluminum door and window cleaning method

【China Aluminum Network】 The first thing to note is that when cleaning, it cannot be used on aluminum frames, nor can it be used as a support. This will cause greater damage to aluminum doors and windows. Aluminum windows and doors can be used soft cloth dipped in water or neutral detergent, ordinary soap and detergent must be avoided, dirt, toilet cleaners and other strong acid and alkali cleaners can not go, or will corrode profiles. If it is found that the seal tops and glass glue fall off, repair them in time and replace them. Ensure aluminum doors and windows sealed and warm. Dry the glass and window frame in time after raining. Always inspect the joints of the door and window frame, tighten the bolts in time, and replace the damaged parts. Positioning pins, wind braces, floor springs and other vulnerable parts of aluminum alloy doors and windows, should be checked from time to time, regularly add oil to keep clean and flexible. Aluminum doors and windows in use, the action should be light, push and pull along the way; find it difficult to hard pull hard push, should be troubleshooting. Ash, deformation is the main reason for the difficulty of sliding aluminum alloy doors and windows, to keep the door frame clean, especially the push-pull tank cleaning. Vacuum cleaner can be used to suck the dust in the groove and door seal tops. Always check the aluminum door and window frame wall joints, if ever loose aluminum doors and windows easily make the frame as a whole deformation, so that doors and windows can not be closed, sealed. Therefore, the looseness of the screws at the joints should be tightened immediately. For example, the screw bases should be loosened, and a small amount of cement should be adjusted by applying epoxy glue.