Inspection and operation of boiler dust removal equipment

Whether the inspection operation handle and the air lock switch before the boiler dust removal equipment are started are flexible and reliable. Check that each flange interface and gasket are in good condition. Open the ash hopper, dust storage tank, dust storage box, etc., and check if there is dust. Inspection and dust removal operation of boiler dust removal equipment 1. Inspection of boiler dust removal equipment before starting
1. Check whether the operation handle of the boiler dust removal equipment and the locker switch are flexible and reliable. Check that each flange interface and gasket are in good condition. Open the ash hopper, dust storage tank, dust storage box, etc., and check if there is dust.
2. During the operation of the boiler bag dust removal equipment, check whether there is any air short circuit between the flange interface and the air locker. Second, boiler dust removal equipment operation
1. The boiler dust removal equipment should be prepared for dust removal before it is shut down. Prepare tools for dust removal, such as cars and water pipes.
2. After the boiler dust removal equipment is out of service, open the sealed door of the dust removal tank and the dust removal box, open the tap water valve, and soak the dust with water.
3. After the dust is soaked, remove the dust and clean it after cleaning.
4. After the dust of the boiler dust removal equipment is completely removed, the half-pool water should be placed in the dust-removing pool to prepare for soaking the dust.
5. Close the dust storage tank and the door of the boiler dust removal equipment, otherwise the air will enter the dust collector from the locker switch, and bring the soot and dust to the atmosphere to reduce the dust removal effect.



Source: http://
Http://news.chinawj.com.cn Inspection and operation of boiler dust removal equipment Editor: (Hardware Business Network Information Center) http://news.chinawj.com.cn Inspection and operation of boiler dust removal equipment

Samarium Cobalt magnets are divided into 2 sort, SmCo5 & Sm2Co17, magnetization from axial direction or dia direction are both available, compared with SmCo5, Sm2Co17 magnets have reduced expensive samarium while the magnetism is rising, moreover, its`reversible temperature coefficient is also better than SmCo5 .For working temperature of Smco Magnet is up to 350℃,thus, its` chemical stability and BH use ratio are better than NdFeB in high temperature environment hence it is widely applied on AC servo motor, operator, industrial motor, sensor, aerospace and military areas,like cup magnet,Round Base Magnet.

Ndfeb MagnetsMagnets

SmCo Magnet

Smco Magnet,Strong Smco Magnet,Permanent Smco Magnet,Smco Magnet Disc,Irregular Smco Magnet,Smco Magnet Block,Cup Magnet,Round Base Magnet

NINGBO SHINE MAGENETIC TECHNOLOGY CO.,LTD , https://www.shinemagnets.com