Correct understanding and construction technology of art paint printing lacquer

Jc001.load('iframe') JIFrame.create({ 'url' : '/go.php?action=ads&iframeHeight=250&isIframe=1&key=%CD%BF%C1%CF&pos_id=jc001_news_detail_30&reqkey=1&style=margin%3A15px+15px+ 25px+0%3B+height%3A255px%3Bwidth%3A255px%3B+float%3Aleft%3B', 'height' : 250 })

The paint in the art paint is also often heard of wallpaper paint and liquid wallpaper paint. It mainly uses titanium dioxide and pearl powder with stable chemical properties as the main material. It is a water-based paint for initial printing on the wall. The product process originated in Italy and was introduced to the country in the early 1990s. After more than ten years, the printing lacquer is widely used in the Chinese market. The printing lacquer construction is simple and convenient. The paint is directly taken out from the packaging tank for construction. It does not need to be diluted and blended, and it is made with plastic scraper, rubber scraper and wire mesh mold. A variety of printing effects.

Although the construction process of the printing lacquer is simple, some details must be done well. First of all, we all know that the wall painting is required. The steps of treating the wall first are required. After the putty is applied, the sandpaper is used after it has dried naturally. Smooth and smooth, use a wool roller to roll the latex paint primer. The primer should be rolled evenly. After drying, gently polish it with the washed sandpaper. Then use a plastic scraper or strip knife to take a small amount of printing paint, the screen mold is fixed by hand on the wall surface, painted with a plastic scraper, the pattern part is as uniform as possible, and the excess printing paint is removed. Finally, carefully remove the screen mold to prevent it from touching the pattern, and the printing effect is completed.

In the above construction sequence, there are several points that must be paid attention to. Before the construction, the paint should be fully stirred, and the appropriate amount of paint should be placed on the inner frame of the mold; the mold is placed at the corner of the wall, and the mold surface is close to the wall. Scratch-After each pattern is scraped, the excess paint on the mold surface is removed; when the wall surface is not enough for the longitudinal and lateral directions, a soft film is used to make up the gap.

Art paint printing varnish can not only make the same effect as wallpaper, but also has excellent performance, various colors, low cost, less coating per unit area, and life test of 8-15 years. It is widely used in the market. The customer's approval, but the art paint brand is also a lot, you need to be cautious when purchasing, so as not to buy inferior paint products.

Commercial blend EPDM Seal is the most economical EPDM sheet offered. Intended to be used in less critical applications where temperatures are of an intermittent nature. Great for outdoor environments. Offers excellent resistance to ozone, oxidants, and severe weather conditions.
Premium EPDM
High Grade EPDM Seal is suited for applications where a high-performance rating is required. It exhibits excellent resistance to heat, ozone and sunlight and has good temperature flexibility. EPDM oil seal.

EPDM Seal

EPDM Seal,EPDM Seals,EPDM Rubber Seals,EPDM Rubber Oil Seals

Shenyang Guide Rubber Products Co.,Ltd , https://www.guiderubber.com