Faucet Installation Steps Faucet Misuse

Water is the source of life, so daily life cannot be separated from water. The faucet is composed of a main body, a valve core, a handle, and the like, and the composition of these parts can well complete the use of water in the daily life of people, and shut down the use of water. Next, we will introduce the faucet installation steps and misuse of the faucets.

Faucet installation steps

First, ask a professional installer to install it. In particular, such faucets, small washers, and small parts are more, they must be installed step by step in order to ensure that there are no problems such as water leakage.

Second, when installing, the faucet is best not to bump with hard objects, can not be cement, glue and other debris left on the surface, to avoid damage to the surface plating gloss.

Thirdly, if a new house is equipped with a faucet and the water pipe network is newly paved, then there will be sand and other impurities in the water. Be sure to remove any debris from the pipe before installation. Discharge water for a long time until the water quality becomes clear.

Fourth, you can't use too much force when you open it. This will cause damage, and you can gently turn with your own hand. Even traditional taps cannot be screwed to death. After use, the faucet surface should be wiped clean. Do not use the handle as a handrail to support or use.

Fifth, if the water pressure is not less than 0.02mpa, after a period of use, if there is a decrease in the amount of water, or even the phenomenon of the water heater turning off, the hot and cold water flow must be shut off. Use a wrench to gently unscrew the water nozzle at the water outlet of the faucet. Net cover, clean impurities and then carefully installed.

Misuse of taps

Misunderstanding 1: Install different types of faucets in different functional areas

There are many types of faucets. Different areas use different faucets. Faucets, sinks, and bath faucets generally use cold and warm styles and bubblers, while washing faucets can use single-cooled faucets. The flushing speed is faster and can have a certain water saving effect.
Misunderstanding 2: The cold and hot water pipes should be kept separate

Hot and cold water faucets can regulate the water temperature through the ceramic valve core. If there is only a cold water pipe, two water inlet hoses can be connected when installing a hot and cold water faucet, and then the upper corner valve can also be used.

Myth No. 3: Faucets and hoses must use angles

All household hot and cold water faucets and water pipes must use angle valves, mainly to prevent water leakage from faucets from affecting water in other areas. The washing machine faucets do not require hot water and can be directly connected to water pipes.

Misunderstanding 4: Faucets need to be replaced regularly

Faucets are generally considered to be replaced after five years of use, because the use of a long time will have a lot of bacteria, dirt, which will cause harm to the human body.

Editor's summary: Regarding the faucet installation procedure and the misuse of the faucet, it was introduced here. I hope to be helpful to everyone, and I would like to know more about the site and information.

Faucet installation

Coloured Lights

Fountain lights, Colored lights, fountain parts

Wuxi Jinshanghua Environmental Equipment Co., Ltd , https://www.jshfountain.com