Wooden door tampering tips

How to prevent insects from wooden doors:

1. In order to prevent wood furniture from being eroded by mites, it can be applied several times with concentrated brine on the surface to prevent mites.

2. Take the camphor oil from the cotton, make the camphor cotton pill, place the piano, wooden furniture, wardrobe, and the flow table to remove the cockroaches and insects.

3. Use the appropriate amount of sharp pepper or pepper, mash into the end, stuff into the pupil, and use boiling water to inject, have the effect of killing insects, can prevent the spread of insects.

4. Mix thoroughly with fire water and trace insecticide water, and drip into the pupil to kill the mites. However, this method is not applicable to bamboo baskets for storing food such as baskets and cabinets.

5. Paint treatment for some corners that have not been damaged, with paint such as raw tung oil, shellac or varnish, brushed to the surface of the wooden cabinet, can make the mites and the air isolated, to achieve the purpose of anti-mite. Note that when painting, the front and back sides and the inner wall of the wooden cabinet should be evenly painted.

6. Chemical treatment When the wooden cabinet is damaged by insects, it can be mixed with dichlorvos and water in a ratio of 1:5, and sprayed with a sprayer to allow the liquid to penetrate into the wooden cabinet. It should be sprayed three times to five times. After 8 hours, all aphids can be killed. After that, wash the wooden cabinet with water and dry it.

7. Wipe with a diesel lamp. Place the wooden cabinet that has been wormed in the sun. Use a brush or cotton yarn to pump the wood cabinet all the way. After drying for two or three hours, apply it again and then expose it to the aphid. Then wash and dry with washing powder

8. After buying the furniture, dip it with 3% sodium fluoride to prevent insects forever.

Electric Ball Valve is operated by electric actuator, the actuator has open close type and regulating type, power 24VDC, 220VAC.  valve have different type and material for optional, socket welding and flanged type, PVC, CPVC, PVDF, PP, PPH, EPDM, PTFE lined. standard following DIN, ANSI, JIS, pressure rate of PN10, PN16, 150LB, 10K. size from 1/2" to 12", limited switch, solenoid valve are optional.

Ningbo RMI Plastic Co.,Ltd offer electric Ball Valve with specification:                                                       

Size:DN15~DN300 (1/2 inch ~ 12 inch)
Connection: Flange DIN PN10, ANSI CL150, JIS10K; socket DIN, ANSI, JIS, CNS, BS; Thread BSPT, NPT.
Body Material: PVDF,PVC,CPVC,PP,PPH,PTFE lined WCB
Seal material: EPDM;FPM;FKM;VITON
Seat Material: PTFE
Design pressure:1.0Mpa(PN10 bar)                                                                                                               

Actuator:Electrical
Operating type:Open/Shut, Regulating
Power supply:DC24V;AC220V;AC380V

Electric Ball Valve

Electric Ball Valve,Ball Valve Electric,Electric Control Ball Valve,Electric Valve

Ningbo RMI Plastic Co., Ltd. , http://www.rmiplast.com