How to choose the right type of rolling bearing

Source: China Bearing Network Time: 2013-02-10

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

There are many types of rolling bearings; the following aspects can be considered when selecting; then selected.
a. The size, direction and nature of the load: ball bearings are suitable for light loads; roller bearings are suitable for heavy loads and impact loads. When the roll shaft receives pure axial loads; thrust bearings are usually used, when the roll shaft receives pure radial When loading; usually use deep groove ball bearings or short cylindrical roller bearings, when the roll shaft receives pure radial load together; there is not much axial load; optional deep groove ball bearings, angular touch ball bearings, cones Roller bearings and self-aligning ball or spherical roller bearings, when the axial load is large; angle contact ball bearings and tapered roller bearings with larger touch angles can be selected; perhaps the combination of radial and thrust bearings is used. This is especially accustomed to very high axial loads or unique requirements for greater axial rigidity.
b. Promising speed: There are big differences in the type of bearing. Under normal circumstances; bearings with small conflict and low heat generation; suitable for high speed. When drawing, it is necessary to work under the condition that the rolling bearing is below its limit speed. .
c. Rigidity: When the bearing receives the load; the bearing ring and the roll body will be elastically deformed; the deformation amount is proportional to the load; the ratio determines the rigidity of the bearing. The bearing can be pre-tensioned to improve the rigidity of the bearing. In the bearing bearing depiction; thinking about the combination and placement of the bearing can also improve the bearing stiffness of the bearing.
d. Self-aligning function and device error: after the bearing is loaded into the working position; often due to the production of error-forming devices and poor positioning. At this moment, the cause of the shaft and the thermal expansion are often caused; the bearing is subjected to excessive load; the early damage is caused. Self-aligning bearings can overcome the shortcomings caused by device errors; therefore, it is suitable for such bearings.
e. Installation and disassembly: tapered roller bearings, needle bearings and tapered roller bearings; bearing types that can be separated from the inner and outer rings (so-called separate bearings);
f. Shopping mall: Even if it is a bearing listed in the catalogue; there are certain sales in the mall, and vice versa; bearings that are not included in the catalogue are produced in large quantities. Therefore, the bearings that should be clearly used can be easily purchased.

.

Recommend to friends comments close window

Bearing related knowledge

Classification of joint bearings Composite smoothing data and bearing production skills Rolling bearing sealing equipment selection and application TIMKEN bearing matters needing attention Bearing grinding processing common sense analysis

This article links to http://
Please indicate the bearing network http://

Previous: Some common problems and protection of CNC machine tool spindles: The use of Delcam software in the production of car cover parts (Part I)

Modular houses are created in sections, and then transported to the home site for construction and installation. Although the sections of the house are prefabricated, the sections, or modules, are put together at the construction much like a typical home. Quick installation is the primary advantage of Modular Building as most of the interior decoration was done in the factory. Zhongda has manufactured modular houses for the US, Australia, and the UK projects in varies of building types such as hotels, apartments, and villas etc.

Modular Building

Modular Building,Modular House,Modular Office Building,Modular Building Construction

Zhongda Steel Structure , http://www.zhongdametal.com